EC Calibration Fluid 12880 μS/cm 20ml Milwaukee
EC fluid 12880 μS/cm for calibration of electronic ec-meters. Manufacturer's code: M10030B
Product code: 999
Leave feedback on the product
EC Calibration Fluid 12880 μS/cm 20ml Milwaukee
large amount
Shipping
from
€2.35
-
DPD Pick-Up Point
(Poland)
from
€2.35
-
DPD Pick-Up Point
(Poland)
DPD Pick-Up Point
Shipping cost for the selected product
The shipping cost applies to this product (in the selected variant - if applicable). It may change after adding other products to the cart.
€1.86
Price
€1.86
The lowest price during 30 days prior to the reduction:
€1.77
The promotion runs until %s
€1.86
Price
€1.86
The lowest price during 30 days prior to the reduction:
€1.77
The promotion runs until %s
Gwarancja bezpiecznego zakupu
Opis produktu
Opis produktu
Milwaukee EC 12880 μS/cm Calibration Fluid – 20 ml Sachet Product Description: Milwaukee M10030 Calibration Fluid is a high-quality 12880 μS/cm conductivity solution used to calibrate electronic EC meters. It is prepared according to the NIST (National Institute of Standards and Technology) standard using potassium chloride, ensuring its accuracy and reliability. Regular calibration is crucial for precise measurements, as EC meter electrodes wear out and can accumulate deposits, which affects their accuracy. Product Features: ✅ Measurement accuracy – based on the NIST 2202 SRM standard, guaranteeing precise results. ✅ Ready-to-use – no dilution required, simply open the sachet and use the solution. ✅ Hermetic packaging – the sachet is protected from air and light, ensuring composition stability. ✅ Calibration chart on the packaging – makes it easier to read results at different temperatures. How to use Milwaukee EC 12880 μS/cm calibration fluid? 1️⃣ Preparation: Check your EC meter's manual to see if it requires calibration at 12880 μS/cm. Make sure the electrode is clean and free of contaminants. 2️⃣ Calibration: Open the pouch by tearing off the top of the pouch. Immerse the meter electrode in the calibration solution. Wait a few seconds for the measurement to stabilize. Adjust the reading on the meter to 12880 μS/cm (according to the device's instructions). 3️⃣ Completion: After calibration, rinse the electrode in deionized water. Discard the pouch after a single use – the solution may lose its effectiveness after opening.
Opinie
Opinie
Number of ratings: 0
If you've added a review and it doesn't appear on the list, it may be pending moderation.
Leave feedback on the product
Log in with Google
